Bilal A Akash Mechanical Engineering Thermals Faculty of Engineering Department of Mechanical Engineering bakash@hu.edu.jo http://www.kfu.edu.sa/en/Colleges/AhsaEngineering/Documents/Faculty%20members/bilal%20home%20page.htm Office No.  : EXT :        C.V. Document file as PDF:

Ph.D. Southern Illinois University The United States of America,1992 Master Southern Illinois University The United States of America,1987 Bachelor Southern Illinois University The United States of America,1984               Air-standard power cycles Fossil fuels Non-conventional energy sources desalination Energy analysis and engineering systems Application of renewable energy systems Geothermal energy           E. Abu-Nada, B. Akash, I. Al-Hinti, A. Al-Sarkhi, S. Nijmeh, A. Ibrahim, A. Shishan, “Modeling of a geothermal standing column well”. International Journal of Energy Research, (2008), 32 (4), 306-317. I. Al-Hinti, B. Akash, E. Abu-Nada, A. Al-Sarkhi, “Performance analysis of air-standard diesel cycle using an alternative irreversible heat transfer approach”. Energy Conversion & Management, (2008), 49, 3301-3304. A. Al-Sarkhi, B. Akash, E. Abu-Nada, S. Nijmeh, I. Al-Hinti, “Prospects of geothermal energy utilization in Jordan”. Energy Sources, Part A, (2008), 30 (17), 1619-1627. E. Abu-Nada, I. Al-Hinti, A. Al-Sarkhi, B. Akash, “Effect of piston friction on the performance of SI engine: A new thermodynamic approach”. ASME Journal of Engineering for Gas Turbines and Power, (2008), 130 (2), Paper No. 022802. A. Al-Ghandoor, I. Al-Hinti, B. Akash, E. Abu-Nada, “Exergy analysis of residential sector in Jordan”. International Journal of Exergy, (2008), 5 (4), 413-428. A. Al-Sarkhi, B. Akash, E. Abu-Nada, I. Al-Hinti, “Efficiency of Atkinson engine at maximum power density using temperature dependent specific heat”. Jordan Journal of Mechanical & Industrial Engineering, (2008), 2, 71-75. A. Al-Sarkhi, E. Abu-Nada, S. Nijmeh, B. Akash, “Performance evaluation of standing column well for potential application of ground-source heat pump in Jordan”. Energy Conversion & Management Journal, (2008), 49 (4), 863-872. E. Abu-Nada, A. Al-Sarkhi, B. Akash, I. Al-Hinti, “Investigation of heat transfer and fluid flow characteristics of separated flows under the effect of suction and blowing”. ASME Journal of Heat Transfer, (2007), 129 (11), 1517-1528. E. Abu-Nada, I. Al-Hinti, B. Akash, A. Al-Sarkhi, “Thermodynamic analysis of spark-ignition engine using a gas mixture model for the working fluid”. International Journal of Energy Research, (2007), 31, 1031-1046. I. Al-Hinti, A. Al-Ghandoor, B. Akash, E. Abu-Nada, “Energy savings and CO2 mitigations through restructuring Jordan’s transportation sector: The diesel passenger cars scenario”. Energy Policy Journal, (2007), 35, 5003-5011. A. Al-Sarkhi, E. Abu-Nada, I. Al-Hinti, B. Akash, “Performance evaluation of a miller engine under various specific heat models”. International Communications in Heat & Mass Transfer, (2007), 34, 897-906. I. Al-Hinti, B. Akash, E. Abu-Nada, A. Al-Sarkhi, “Performance analysis of air-standard diesel cycle using an alternative irreversible heat transfer approach”. Third International Conference on Thermal Engineering Theory and Applications, (2007), Amman, Jordan. A. Al-Ghandoor, I. Al-Hinti, B. Akash, “Potential Electrical Energy Saving Opportunities in the Jordanian Plastic Industry”. Third International Conference on Thermal Engineering Theory and Applications, (2007), Amman, Jordan. E. Abu-Nada, I. Al-Hinti, A. Al-Sarkhi, B. Akash, “Thermodynamic modeling of spark-ignition engine: Effect of temperature dependent specific heats”. International Communications in Heat & Mass Transfer, (2006), 33, 1264-1272. S. Odeh, B. Akash, J. Jaber, M. Droubi, S. Touri, W. Farajallah, “Flow chart of energy waste in Jordan”. International Journal of Mechanical & Materials Engineering, (2006), 1 (2), 76-81. B. Akash, E. Abu-Nada, A. Al-Sarkhi, A. Shishan, A. Ibrahim, S. Nijmeh, “Three-dimensional simulation of a standing column well for potential applications in Jordan”. Global Conf. of Renewable Energy Approaches in Desert Regions, (2006), Amman, Jordan. A. Al-Sarkhi, B. Akash, E. Abu-Nada, S. Nijmeh, “On the situation of geothermal energy utilization in Jordan”. Global Conf. of Renewable Energy Approaches in Desert Regions, (2006), Amman, Jordan. B. Akash, “Combustion of diesel and kerosene in water jacketed horizontal cylinder combustion unit”, The Second International Conference on Thermal Engineering Theory and Applications, (2006) Al-Ain, UAE. E. Abu-Nada, A. Al-Sarkhi, B. Akash, S. Nijmeh, “Parametric analysis of a standing column well using a simplified one-dimensional model”. 19th Int. Conf. on Efficiency, Cost, Optimization, Simulation & Environmental Impact of Energy Systems, (2006), Crete, Greece.                                                           Editor-in-Chief International Journal of Thermal and Environmental Engineering (e-mail: ijtee@iasks.org ) ISSN: 1923-7308 (Print), ISSN: 1923-7316 (Online) International Association for Sharing Knowledge and Sustainability http://www.iasks.org/journals/ijtee

     Back